Standing seam and metal panel roofing, roof repair and full replacement in Oneida. We show up when we say we will, and we clean up before we go.
Everything we do on a roof, done by crews who have been doing it the same careful way since 2002.
Old skylights leak at the flashing long before the glass ever fails. We reflash, reseal, or set a new unit and tie it in properly.
After a storm we walk the roof, photograph everything we find, and write an itemized estimate you can hand straight to your adjuster.
Guards installed as part of a roof job or on their own. Either way we check the hangers and the pitch while we are up there.
The edge of a roof is where most trouble starts. New fascia, new soffit, wrapped or painted so it stays sound.
Water runs along decking and rafters before it ever drips, so the stain is rarely under the hole. We trace the leak back to where it really starts and fix that.
A careful walk over the whole roof — panels, shingles, valleys, flashing, fasteners — plus the attic side when there is a way in. You get photos and a straight answer.
An older roof deserves to keep its character. We repair rather than replace wherever the material still allows it.
Repair or replace, we handle both, and we work from what the roof actually needs rather than from what an adjuster might approve.
Missing shingles get matched as close as weathering allows. Loose metal gets new fasteners and washers, and the eaves, rakes and ridge get sealed back up tight.
Full tear off, decking checked board by board, then a new metal or shingle roof over proper underlayment. You get the price and the start date before anything comes off.
Porch roofs, additions and low slope sections that hold water instead of shedding it. We rework the flashing, seal the seams, and get water moving again.
We work around your hours, weekends included when that is what it takes to keep your doors open while the roof goes on.
Coatings for low slope and older metal roofs that are still sound but weathered. Washed down, refastened, primed at the rust, then coated.
Lifted panels, missing shingles, flashing that has given up where the chimney comes through. We find what is actually wrong, fix that, and leave the rest of your roof alone.
This is the work our name is attached to. Two decades of tin roofs on houses, churches, barns and additions, installed by crews who cut the trim on site instead of forcing something that almost fits.
Underlayment, ice and water shield in the valleys and along the eaves, sealed penetrations, and proper closures at the ridge.
We repair standing seam, exposed fastener panels and metal shingles, and we match the color as closely as the paint system will allow.
A limb through the roof or panels peeled back overnight needs covering now, not next week. We get it dried in first so the inside of the house stops taking damage.
From a few tabs to a whole slope, we fix shingle roofs without pushing you toward a replacement you are not ready for.
Removing the ice is the easy half. We also look at ventilation and insulation so it stops happening every January.
Our crews in Oneida work the way this family has always worked — on time, cleaned up, and finished before anybody calls it finished. You will know who is coming, what day they are coming, and what the number is before anything starts.
If weather moves your Oneida job, we call you. If we open the roof and find rotten decking, we show you the boards and price the change before we touch it. Nobody likes surprises on a roof, us included.
Why people around Oneida call us back and send their neighbors our way.
The same family started this company putting metal roofs on neighbors houses in 2002. It has never been sold, franchised or handed off to a call center.
Around twenty standard metal colors, and the chart comes out with the estimate so you can hold it up against your siding and shutters before you commit.
Standing seam and metal panel roofs are the work we are known for. Color, trim, fastening pattern — we have done hundreds and we will walk you through all of it.
Beds get covered, tear off gets hauled as we go, and a magnet goes over the drive before we pull out. Your yard should look like we were never there.
You get a start date and we hold to it. If weather moves your job we call you, rather than leaving you watching the driveway.
Straight answers to what Oneida homeowners ask us most often.
No. Estimates are always free in Oneida. We come out, measure, look in the attic if we can get to it, and leave you a written price. Nobody will push you to sign anything that day, and the number does not expire in an hour.
Sometimes. If the decking is sound and there is only one layer of shingles, a Oneida metal roof can go over the top on purlins. If there is rot underneath or two layers already on, we tear off first — and we will tell you that before you sign, not halfway through.
Most Oneida metal roof jobs land somewhere between about $12,000 and $30,000 in 2026, depending on square footage, pitch, panel type and how much tear off there is. Standing seam runs higher than exposed fastener panels. We measure before we quote, and the estimate is free.
Yes. Gutters, guards, soffit and fascia are all part of keeping the edge of a Oneida roof dry, so we handle them along with the roof instead of sending you off to find somebody else to finish the job.
A typical Oneida shingle roof runs roughly $8,000 to $18,000 in 2026 for an average single family home, and more if the deck has rot or the roof is steep and cut up with dormers. We do not price off a satellite photo — somebody comes out and measures.
Any dry stretch works. We roof in Oneida year round, though we schedule shingle work for when it is warm enough for the strips to seal properly, and we watch the forecast so your house is never left open overnight.
Real feedback from homeowners whose roofs we have worked on.
"The crew was polite, cleaned up every day, and ran a magnet over the driveway before they left. My kids never found a single nail."
"Thank you so much to the entire crew at Roofing Brothers for our amazing new tin roof! You were amazing to work with and I couldn't recommend you to others enough! Great communication, pricing, color options, efficiency, and HONESTY! If anyone needs a new roof, I highly recommend this crew! Phenomenal job."
"Standing seam on our log home. The panels are dead straight and the ridge work is clean. You can tell they have done a few of these."
Roofing Brothers also serves these towns near Oneida.